Figure 29: Acl Port Configuration - SMC Networks SMCGS10C-SMART Management Manual

| Configuring the Switch
C 4
HAPTER
Configuring Security
Repeat the preceding step for each port to which an ACL will be applied.
3.
Click Save.
4.

Figure 29: ACL Port Configuration

C R L
ONFIGURING ATE IMITERS
Use the ACL Rate Limiter Configuration page to define the rate limits
applied to a port (as configured either through the ACL Ports Configuration
menu (page 88) or the Access Control List Configuration menu
P
ATH
Configuration, Security, Network, ACL, Rate Limiters
P
ARAMETERS
These parameters are displayed:
Rate Limiter ID - Rate limiter identifier. (Range: 0-14; Default: 1)
◆
Rate - The threshold above which packets are dropped.
◆
(Options: 0-100 pps, or 0, 100, 2*100, 3*100, ... 1000000 kbps)
Due to an ASIC limitation, the enforced rate limits are slightly less than
the listed options. For example: 1 Kpps translates into an enforced
threshold of 1002.1 pps.
◆ Unit - Unit of measure. (Options: pps or kbps; Default: pps)
W I
EB NTERFACE
To configure rate limits which can be applied to a port:
Click Configuration, Security, Network, ACL, Rate Limiters.
1.
For any of the rate limiters, select the maximum ingress rate that will
2.
be supported on a port once a match has been found in an assigned
ACL.
Click Save.
3.
– 90 –
(page 91).