Displaying Information About Learned Mac Addresses; Figure 96: Port Security Port Status - SMC Networks SMCGS10C-SMART Management Manual

D
ISPLAYING
I A
NFORMATION BOUT
L MAC
EARNED
A
DDRESSES
Use the Port Security Port Status page to show the entries authorized by
port security services, including MAC address, VLAN ID, time added to
table, age, and hold state.
P
ATH
Monitor, Security, Network, Port Security, Port
P
ARAMETERS
These parameters are displayed:
MAC Address – The MAC address seen on this port. If no MAC
◆
addresses are learned, a single row stating "No MAC addresses
attached" is displayed.
VLAN ID – The VLAN ID seen on this port.
◆
State – Indicates whether the corresponding MAC address is blocked
◆
or forwarding. In the blocked state, it will not be allowed to transmit or
receive traffic.
◆ Time Added – Shows the date and time when this MAC address was
first seen on the port.
Age/Hold – If at least one user module has decided to block this MAC
◆
address, it will stay in the blocked state until the hold time (measured
in seconds) expires. If all user modules have decided to allow this MAC
address to forward, and aging is enabled, the Port Security module will
periodically check that this MAC address is still forwarding traffic. If the
age period (measured in seconds) expires and no frames have been
seen, the MAC address will be removed from the MAC table. Otherwise
a new age period will begin.
If aging is disabled or a user module has decided to hold the MAC
address indefinitely, a dash (-) will be shown.
W I
EB NTERFACE
To display information about the MAC address learning through the Port
Security module, click Monitor, Security, Network, Port Security, Port.

Figure 96: Port Security Port Status

– 209 –
| Monitoring the Switch
C 5
HAPTER
Displaying Information About Security Settings