Configuring Egress Port Scheduler; Figure 70: Configuring Ingress Port Tag Classification - SMC Networks SMCGS10C-SMART Management Manual

C E
ONFIGURING GRESS
P S
ORT CHEDULER
Set the tag classification mode to Disabled to use the default QoS class
3.
and DP level for tagged frames, or to Enabled to use the mapped
versions of PCP and DEI for tagged frames.
Click Save.
4.

Figure 70: Configuring Ingress Port Tag Classification

Use the QoS Egress Port Schedulers page to show an overview of the QoS
Egress Port Schedulers, including the queue mode and weight. Click on any
of the entries in the Port field to configure egress queue mode, queue
shaper (rate and access to excess bandwidth), and port shaper.
P
ATH
Configuration, QoS, Port Scheduler
P
ARAMETERS
These parameters are displayed:
Displaying QoS Egress Port Schedulers
Port – Port identifier.
◆
Mode – Shows the scheduling mode for this port.
◆
Weight – Shows the weight of each egress queue used by the port.
◆
Configuring QoS Egress Port Scheduler, Queue Scheduler and Port Shapers
Scheduler Mode – The switch can be set to service the queues based
◆
on a strict rule that requires all traffic in a higher priority queue to be
– 175 –
| Configuring the Switch
C 4
HAPTER
Quality of Service