Displaying Lldp-Med Neighbor Information; Figure 121: Lldp Neighbor Information - SMC Networks SMCGS10C-SMART Management Manual

◆
W
To display information about LLDP neighbors, click Monitor, LLDP,
Neighbors.

Figure 121: LLDP Neighbor Information

Use the LLDP-MED Neighbor Information page to display information about
D LLDP-
ISPLAYING
a remote device connected to a port on this switch which is advertising
MED N
EIGHBOR
LLDP-MED TLVs, including network connectivity device, endpoint device,
I
NFORMATION
capabilities, application type, and policy.
P
ATH
Monitor, LLDP, LLDP-MED Neighbors
P
ARAMETERS
These parameters are displayed:
◆
◆
Management Address – The IPv4 address of the remote device. If no
management address is available, the address should be the MAC
address for the CPU or for the port sending this advertisement.
If the neighbor device allows management access, clicking on an entry
in this field will re-direct the web browser to the neighbor's
management interface.
I
EB NTERFACE
Port - The port on which an LLDP frame was received.
Device Type - LLDP-MED devices are comprised of two primary types:
LLDP-MED Network Connectivity Devices – as defined in TIA-1057,
■
provide access to the IEEE 802 based LAN infrastructure for LLDP-
MED Endpoint Devices. An LLDP-MED Network Connectivity Device
is a LAN access device based on any of the following technologies:
LAN Switch/Router
■
IEEE 802.1 Bridge
■
IEEE 802.3 Repeater (included for historical reasons)
■
IEEE 802.11 Wireless Access Point
■
Any device that supports the IEEE 802.1AB and MED extensions
■
defined by TIA-1057 and can relay IEEE 802 frames via any
method.
LLDP-MED Endpoint Device – Within this category, the LLDP-MED
■
scheme is broken into further Endpoint Device Classes, as defined
in the following.
Each LLDP-MED Endpoint Device Class is defined to build upon the
capabilities defined for the previous Endpoint Device Class. Fore-
– 241 –
| Monitoring the Switch
C 5
HAPTER
Displaying LLDP Information