Filtering Ip Addresses For Management Access; Figure 18: Https Configuration; Table 5: Https System Support - SMC Networks SMCGS10C-SMART Management Manual

F IP
ILTERING
A
DDRESSES FOR
M A
ANAGEMENT CCESS
The following web browsers and operating systems currently support
◆
HTTPS:

Table 5: HTTPS System Support

Web Browser
Internet Explorer 5.0 or later
Netscape 6.2 or later
Mozilla Firefox 2.0.0.0 or later
P
ARAMETERS
These parameters are displayed:
Mode - Enables HTTPS service on the switch. (Default: Enabled)
◆
Automatic Redirect - Sets the HTTPS redirect mode operation. When
◆
enabled, management access to the HTTP web interface for the switch
are automatically redirected to HTTPS. (Default: Disabled)
W I
EB NTERFACE
To configure HTTPS:
Click Configuration, HTTPS.
1.
Enable HTTPS if required and set the Automatic Redirect mode.
2.
Click Save.
3.

Figure 18: HTTPS Configuration

Use the Access Management Configuration page to create a list of up to 16
IP addresses or IP address groups that are allowed management access to
the switch through the web interface, or SNMP, or Telnet.
The management interfaces are open to all IP addresses by default. Once
you add an entry to a filter list, access to that interface is restricted to the
specified addresses. If anyone tries to access a management interface on
the switch from an invalid address, the switch will reject the connection.
P
ATH
Configuration, Security, Switch, Access Management
– 63 –
| Configuring the Switch
C 4
HAPTER
Operating System
Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Windows Vista, Windows 7
Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Windows Vista, Solaris 2.6
Windows 2000, Windows XP, Windows Vista, Linux
Configuring Security