| Configuring the Switch
C
4
HAPTER
Quality of Service
C
DSCP
ONFIGURING
T
RANSLATION
Figure 77: Configuring DSCP-based QoS Ingress Classification
. . .
Use the DSCP Translation page to configure DSCP translation for ingress
traffic or DSCP re-mapping for egress traffic.
P
ATH
Configuration, QoS, DSCP Translation
P
ARAMETERS
These parameters are displayed:
DSCP – DSCP value. (Range: 0-63)
◆
◆
Ingress Translate – Enables ingress translation of DSCP values based
on the specified classification method.
Ingress Classify – Enable Classification at ingress side as defined in
◆
the QoS Port DSCP Configuration table (see
Egress Remap DP0 – Re-maps DP0 field to selected DSCP value. DP0
◆
indicates a drop precedence with a low priority.
Egress Remap DP1 – Re-maps DP1 field to selected DSCP value. DP1
◆
indicates a drop precedence with a high priority.
– 184 –
page
181).