SMC Networks SMCGS10C-SMART Management Manual page 107

changes will only become active after ARP Inspection is enabled
globally again.
ARP Inspection uses the DHCP snooping bindings database for the list
◆
of valid IP-to-MAC address bindings.
DHCP snooping must be enabled for dynamic clients to be learned
N :
OTE
automatically.
C G
ONFIGURING LOBAL AND
Use the ARP Inspection Configuration page to enable ARP inspection
globally for the switch and for any ports on which it is required.
P
ATH
Configuration, Security, Network, ARP Inspection, Configuration
P
ARAMETERS
These parameters are displayed:
ARP Inspection Configuration
Mode – Enables Dynamic ARP Inspection globally. (Default: Disabled)
◆
Port Mode Configuration
Port – Port identifier
◆
Mode – Enables Dynamic ARP Inspection on a given port. Only when
◆
both Global Mode and Port Mode on a given port are enabled, will ARP
Inspection be enabled on a given port. (Default: Disabled)
W I
EB NTERFACE
To configure global and port settings for ARP Inspection:
Click Configuration, Security, Network, ARP Inspection, Configuration.
1.
Enable ARP inspection globally, and on any ports where it is required.
2.
Click Save.
3.
– 107 –
C 4
HAPTER
P S ARP I
ORT ETTINGS FOR
| Configuring the Switch
Configuring Security
NSPECTION