SMC Networks SMCGS10C-SMART Management Manual page 154

| Configuring the Switch
C 4
HAPTER
Link Layer Discovery Protocol
Tagged indicates that the device is using the IEEE 802.1Q tagged
frame format, and that both the VLAN ID and the Layer 2 priority
values are being used, as well as the DSCP value. The tagged
format includes an additional field, known as the tag header. The
tagged frame format also includes priority tagged frames as defined
by IEEE 802.1Q-2003.
VLAN ID – VLAN identifier for the port. (Range: 1-4095)
■
L2 Priority – Layer 2 priority used for the specified application
■
type. L2 Priority may specify one of eight priority levels (0 - 7), as
defined by IEEE 802.1D-2004. A value of 0 represents use of the
default priority as defined in IEEE 802.1D-2004.
DSCP – DSCP value used to provide Diffserv node behavior for the
■
specified application type as defined in IETF RFC 2474. DSCP may
contain one of 64 code point values (0 - 63). A value of 0 represents
use of the default DSCP value as defined in RFC 2475.
Policy Port Configuration – Every port may advertise a unique set of
◆
network policies or different attributes for the same network policies,
based on the authenticated user identity or port configuration.
Port – The port number for which the configuration applies.
■
Policy ID – The set of policies that apply to a given port. The set of
■
policies is selected by marking the check boxes that correspond to
the required policies.
W I
EB NTERFACE
To configure LLDP-MED TLVs:
Click Configuration, LLDP-MED.
1.
Modify any of the timing parameters as required.
2.
Set the fast start repeat count, descriptive information for the end-
3.
point device, and policies applied to selected ports.
Click Save.
4.
– 154 –