SMC Networks SMCGS10C-SMART Management Manual page 189

IP Fragment – Indicates whether or not fragmented packets
■
are accepted. (Options: Any, Yes, No; Default: Any)
Datagrams may be fragmented to ensure they can pass through
a network device which uses a maximum transfer unit smaller
than the original packet's size.
DSCP – Diffserv Code Point value. (Options: Any, specific value
■
of 0-63, BE, CS1-CS7, EF or AF11-AF43, or Range;
Default: Any)
IPv6 – IPv6 frame type includes the same settings as those used
■
for IPv4, except for the Source IP. When configuring a specific IPv6
source address, enter the least significant 32 bits (a.b.c.d) using
the same type of mask as that used for an IPv4 address.
Sport – Source TCP/UDP port. (Any, Specific/Range: 0-65535)
■
Dport – Destination TCP/UDP port. (Any,
■
Specific/Range: 0-65535)
Action Parameters
Action – Indicates the classification action taken on ingress frame if
◆
the configured parameters are matched in the frame's content. If a
frame matches the QCE, the following actions will be taken:
Class (Classified QoS Class) – If a frame matches the QCE, it will be
◆
put in the queue corresponding to the specified QoS class, or placed in
a queue based on basic classification rules. (Options: 0-7, Default (use
basic classification); Default setting: 0)
◆ DPL – The drop precedence level will be set to the specified value or
left unchanged. (Options: 0-1, Default; Default setting: Default)
DSCP – The DSCP value will be set to the specified value or left
◆
unchanged. (Options: 0-63, BE, CS1-CS7, Default (not changed);
Default setting: Default)
W I
EB NTERFACE
To configure QoS Control Lists:
Click Configuration, QoS, QoS Control List.
1.
Click the button to add a new QCE, or use the other QCE
2.
modification buttons to specify the editing action (i.e., edit, delete, or
moving the relative position of entry in the list).
When editing an entry on the QCE Configuration page, specify the
3.
relevant criteria to be matched, and the response to a match.
Click Save.
4.
– 189 –
| Configuring the Switch
C 4
HAPTER
Quality of Service