Figure 20: Snmp System Configuration - SMC Networks SMCGS10C-SMART Management Manual

In the SNMP Trap Configuration table, enable the Trap Mode to allow
3.
the switch to send SNMP traps. Specify the trap version, trap
community, and IP address of the management station that will receive
trap messages either as an IPv4 or IPv6 address. Select the trap types
to issue, and set the trap inform settings for SNMP v2c or v3 clients.
For SNMP v3 clients, configure the security engine ID and security
name used in v3 trap and inform messages.
Click Save.
4.

Figure 20: SNMP System Configuration

S SNMP 3 C
ETTING V OMMUNITY
Use the SNMPv3 Community Configuration page to set community access
strings. All community strings used to authorize access by SNMP v1 and
v2c clients should be listed in the SNMPv3 Communities Configuration
table. For security reasons, you should consider removing the default
strings.
P
ATH
Configuration, Security, Switch, SNMP, Communities
P
ARAMETERS
These parameters are displayed:
– 69 –
| Configuring the Switch
C 4
HAPTER
A S
CCESS TRINGS
Configuring Security