Parameters And Menus - Omron E5EK DEVICENET User Manual

CHAPTER 1 INTRODUCTION

1.3 Parameters and Menus

J Parameter types
F Protect mode
F Manual mode
F Level 0 mode
F Level 1 mode
F Level 2 mode
F Setup mode
F Expansion mode
Differences from
General-purpose
Models
1--6
E5EK-DRT parameters are distributed between the following nine
modes.
Protect mode
Manual mode
Level 0 mode
Level 1 mode
Level 2 mode
Setup mode
Expansion mode
Option mode
Calibration mode
The settings of parameters in each of seven modes (excluding the pro-
tect mode and manual mode) can be checked and modified by selection
on the menu display.
This mode is used to limit use of the keys. The protect function is for
preventing unwanted modification of parameters and switching
between the auto and manual operation.
In this mode, the controller can be switched manual operation. The
manipulated variable can be manipulated manually only in this mode.
Set the controller to this mode during normal operation. In this mode,
you may change the set point during operation, and stop and start op-
eration. You can also monitor (not change) the process value, ramp SP
and manipulated variable.
This is the main mode for adjusting control. In this mode, you can
execute AT (auto-tuning), and set alarm values, the control period, PID
parameters and heater burnout alarm (HBA) conditions.
This is the auxiliary mode for adjusting control. In this mode, you can
set the parameters for limiting the manipulated variable, switch
between the remote and local modes, switch between the SP modes, and
set the loop break alarm (LBA), alarm hysteresis and the digital filter
value of inputs.
This is the mode for setting the basic specifications. In this mode, you
can set parameters that must be checked or set before operation such as
the input type, scaling, output assignments and direct/reverse opera-
tion.
This is the mode for setting expanded functions. In this mode, you can
set, SP setting limiter, selection of 2-PID control or ON/OFF control,
specification of the standby sequence resetting method, time for auto-
matic return to the monitoring display.
New function Functions not supported
CompoBus/D Serial communications
(DeviceNet) Position-proportional control
Event input
Multi-SP
Transfer output
Self-tuning (ST)