Omron E5EK DEVICENET User Manual page 118

CHAPTER 7 CALIBRATION
7.1 Structure of Parameters
Thermocouple 1
7--2
• To calibrate the E5EK-DRT controller, select [
display to select the calibration mode. [
• However, note that [
when, for example, the user is calibrating the E5EK-DRT controller
for the first time. If this happens, [
"security" parameter (protect mode) to "0".
• The parameters in the calibration mode are configured as follows.
Platinum resistance
Thermocouple
thermometer
Platinum
resistance
thermometer 1
Thermocouple 2
• To select the desired parameter, press the
displayed in the following order:
Calibration of inputs → Saving of calibration data
• Only inputs that have been set in the "input type" parameter (setup
mode) can be calibrated. To temporarily save data for each of the cal-
ibration parameters, press the
• The data save menu is displayed only when all calibration items have
temporarily been saved.
• After calibrating input, you must always check indication accuracy.
For details, see page 7-12.
] may not be displayed on the menu display
Current input
Platinum
resistance
thermometer 2
Thermocouple 1 : K / J / L / E / N / W / PLII
Thermocouple 2 : K / J / L / R / S / B / T / U
Platinum resistance
: JPt100/Pt100
thermometer 1
Platinum resistance
: Pt100
thermometer 2
key for 1 second.
] in the menu
] is displayed.
] is displayed by changing the
Voltage input
0 to 5VDC
1 to 5VDC
0 to 10VDC
key. Parameters are