Omron E5EK DEVICENET User Manual page 89

t
• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" and "1".
• This mode contains the parameters for setting expanded functions. These parame-
ters, for example, are for selecting the SP setting limiter, 2-PID and ON/OFF, spec-
ifying the standby sequence reset method, and setting the automatic return to the
monitoring display.
• To select this mode when in the levels 0 to 2, setup, option and calibration modes,
press the
play. If you select [
cond minimum, the controller enters the expansion mode.
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
key for 1 second minimum. The display changes to the menu dis-
] using the
or keys.
Symbol
SP setting upper limit
SP setting lower limit
PID / ON/OFF
α
AT calculated gain
Standby sequence reset method
Automatic return of display mode
AT hysteresis
LBA detection width
Expansion Mode
key then press the
key. To change parameter set-
Parameter Name
key for 1 se-
Page
5-32
5-32
5-32
5-33
5-33
5-34
5-34
5-35
5-35
5--31