Omron E5EK DEVICENET User Manual page 73

Control period (heat)
Control period (cool)
• Sets the pulse output period. Set the control period taking the control characteris-
tics and life expectancy of the controller into consideration.
• In standard control, use the "control period (heat)" parameter. The "control
Function
period (cool)" parameter cannot be used.
• In heating and cooling control, the control period can be set independently for
heating and cooling. Use the "control period (heat)" parameter to set the heating
side control period, and use the "control period (cool)" parameter to set the cool-
ing side control period.
Control period (heat)
Control period (cool)
Comment
F Related article
3.3 Setting Output Specifications (page 3-7)
F Related parameters
See
"Control output 1 assignment" "Control output 2 assignment" (setup mode)
Heater current monitor
• Measures the current value of the heater from CT input.
• This parameter is not displayed when the linear output unit (E53-Cj, E53-Vj) is
mounted.
Function
Monitor Range
0.0 to 55.0
• [
Monitor
F Related article
4.4 How to Use the Heater Burnout Alarm (page 4-9)
F Related parameters
See
"Heater burnout" (level 1 mode) "HBA latch" (option mode)
Parameter Setting Range
1 to 99
1 to 99
Unit
A
] is displayed when 55.0 A is exceeded.
Level 1 Mode
Conditions of Use
Relay, SSR or voltage output must be
set as the outputs, and the control must
be set to 2-PID control, standard control
or heating and cooling control.
Unit Default
Second 20
Second 20
Conditions of Use
The HBA output function must be
assigned.
5--15