Omron E5EK DEVICENET User Manual page 146

APPENDIX
PARAMETER OPERATIONS LIST
• Switching to modes other than manual or protect mode is carried out by mode selection in the
menu display.
• The figure below shows all parameters in the order that they are displayed. Some parameters are
not displayed depending on the protect mode setting and conditions of use.
Level 0
PV/SP
Remote SP monitor
Set point during SP ramp
MV monitor (heat)
MV monitor (cool)
Run/Stop
Manual
Manual MV
Protect
Security
[A/M] key protect
A--10
Power ON
1 second min.
Level 0
1 second min.
Level 1
1 second min.
Level 2
1 second min.
Setup
1 second min.
Expansion
1 second min.
Option
1 second min.
Calibration
Level 1
AT Execute/Cancel
Alarm value 1
Alarm value 2
Alarm value 3
Proportional band
Integral time
Derivative time
Cooling coefficient
Dead band
Manual reset value
Hysteresis (heat)
Hysteresis (cool)
Control period (heat)
Control period (cool)
Heater current monitor
Heater burnout
A/M
1 second min.
Manual
A/M
1 second min.
+ +
A/M
A/M
1 second min. 1 second min.
Protect
A/M
1 second min.
Parameters in a mode can be
switched by the key. The param-
eter following the last parameter is the
top parameter.
Level 2
Remote/Local
SP mode
SP ramp time unit
SP ramp set value
LBA detection time
MV at stop
MV at PV error
MV upper limit
MV lower limit
MV change rate limit
Input digital filter
Alarm 1 hysteresis
Alarm 2 hysteresis
Alarm 3 hysteresis
Input shift upper limit
Input shift lower limit
+