Omron E5EK DEVICENET User Manual page 94

CHAPTER 5 PARAMETERS
Option Mode
• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" and "1".
• You can display this mode only on controller models that support the option func-
tions. In this mode, you set communications conditions and communications data
assignment parameters to match the type of option function.
• To select this mode when in the levels 0 to 2, setup, expansion and calibration
modes, press the
display. If you select [
second minimum, the controller enters the option mode.
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
5--36
key for 1 second minimum. The display changes to the menu
] using the
or keys.
Symbol
Baud rate
Node address
Communication data format
Operation at communication error
Read data assignment 1 to 16
Write data assignment 1 to 16
HBA latch
Remote SP enable
Remote SP upper limit
Remote SP lower limit
SP tracking enable
key then press the
key. To change parameter set-
Parameter Name
key for 1
Page
5-37
5-37
5-37
5-38
5-38
5-38
5-39
5-39
5-40
5-40
5-41