Omron E5EK DEVICENET User Manual page 64

CHAPTER 5 PARAMETERS
Level 0 Mode
• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" to "4".
• The "PV/SP" parameter can be used when the "security" parameter is set to "5"
or "6". However, note that the SP cannot be changed when it is set to "6".
• This mode is used for changing the SP value and starting or stopping operation.
The mode can also be used for monitoring the PV value, set point during SP ramp,
or MV value, but cannot be used for changing them.
• To select this mode when in the levels 1 and 2, setup, expansion, option and cal-
ibration modes, press the
the menu display. If you select [
second minimum, the controller enters the level 0 mode.
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
5--6
or keys.
Symbol
Parameter Name
PV/SP
Remote SP monitor
Set point during SP ramp
MV monitor (heat)
MV monitor (cool)
Run/Stop
key for 1 second minimum. The display changes to
] using the
key. To change parameter set-
key then press key for 1
Page
5-7
5-8
5-8
5-9
5-9
5-9