Omron E5EK DEVICENET User Manual page 80

CHAPTER 5 PARAMETERS
Level 2 Mode
Input digital filter
• Sets the time constant of the input digital filter. The following figures shows the
effect on data after passing through the digital filter.
Function
Comment
Alarm 1 hysteresis
Alarm 2 hysteresis
Alarm 3 hysteresis
• This parameter is for setting the hysteresis of alarm outputs 1 to 3.
Function
Comment
F Related article
3.4 Setting Alarm Type (page 3-10)
F Related parameters
See
"Alarm 1 type" "Alarm 2 type" "Alarm 3 type" "Alarm 1 open in alarm" "Alarm 2
open in alarm" "Alarm 3 open in alarm" (setup mode)
"Alarm value 1" "Alarm value 2" "Alarm value 3" (level 1 mode)
5--22
PV before passing through filter
A
Time
constant
Input digital filter
Unit
Setting Range
0 to 9999 Second
Unit
Setting Range
0.01 to 99.99 %FS
PV after passing through filter
0.63A
Time
Default
0
Conditions of Use
Alarms must be assigned as outputs.
For example, if alarm outputs 1 and 2
only are assigned as outputs, the "alarm
3 hysteresis" parameter cannot be used.
Default
0.02