Cpu Settings Tab Page - Omron CJ - 09-2009 Operation Manual

PLC Setup
Mode Setting
Programming
Console address
Word Bit(s)
+81 --- Program (PRG):
PROGRAM mode
Monitor (MON):
MONITOR mode
Run (RUN): RUN
mode
Use programming
console (PRNC):
Programming Con-
sole's mode switch
Default: Use pro-
gramming console
Execution Settings
Startup Condition (CJ1-H CPU Units Only)
Programming
Console address
Word Bit(s)
+83 15 0: Wait for Units.
1: Don't wait.
Default: 0
7-1-2-2

CPU Settings Tab Page

290
Settings
This setting determines whether the Startup
Mode will be the mode set on the Program-
ming Console's mode switch or the mode
set here in the PLC Setup.
Note If this setting is PRCN and a
Programming Console isn't
connected, startup mode will be
RUN mode.
Settings
To start the CPU Unit in MONITOR or PRO-
GRAM mode even if there is one or more
Units that has not completed startup pro-
cessing, set this setting to 1 (Don't wait for
Units).
To wait for all Units to finish startup process-
ing, set this setting to 0 (Wait for Units).
Note This setting applies only to specific Units. If "don't wait" is set, the CPU Unit
will not wait only for those specific Units, i.e., it will still wait for all other Units
to start.
Function
Function
Section 7-1
Related When set-
flags and ting is read
words by CPU Unit
--- At startup
Related When set-
flags and ting is read
words by CPU Unit
--- At startup