Omron CJ - 09-2009 Operation Manual page 250

B7A Interface Unit
CJ1W-B7A04
CJ1W-B7A22
Transmission Delay Switch
202
B 7 A 0 4 C J
R U N
Display Name
RUN B7A operating
status
B 7 A 2 2 C J
R U N
E R R 1
E R R 2
Display Name
RUN B7A operating
status
ERR1 Port 3 trans-
mission error
ERR2 Port 4 trans-
mission error
3 ms
Name
Transmission delay
switch
Note The switch setting is read when the power is turned ON or the Unit is
restarted. If the switch setting is changed after turning ON the power or
restarting the Unit, the setting will not be read.
Color Status
Green ON
OFF
Color Status
Green ON
OFF
Red ON
OFF
Red ON
OFF
19 ms
Function
The same baud rate is set for all ports
using this one switch.
Right: Standard (19.2 ms typical)
Left: High-speed (3 ms typical)
Section 3-7
Condition
The B7A Unit is operating.
The B7A Unit is stopped.
Condition
The B7A Unit is operating.
The B7A Unit is stopped.
A transmission error has occurred
at port 3 of the B7A Unit.
The Unit is operating normally.
A transmission error has occurred
at port 4 of the B7A Unit.
The Unit is operating normally.
Factory setting
Standard