Omron CJ - 09-2009 Operation Manual page 265

Examples
1,2,3...
6. Setting the PLC Setup
3. Right-click the slots to be edited and select the desired Units from the pull-
down menu.
4. Select Options and then Transfer to PLC to transfer the I/O table to the
CPU Unit.
Note The first word allocated to each Rack can be set from the Programming
Device.
Using a Programming Console
Use the following procedure to register the I/O table with a Programming Con-
sole.
1. Install all of the Units in the PLC.
2. Connect the Programming Console to the peripheral port.
(It can be connected with the power ON.)
3. Perform the following Programming Console operation.
FUN
Specify holding or clearing
CPU Bus Unit information.
These settings are the CPU Unit's software configuration.
Making the Settings with the CX-Programmer
1. Double-click the Settings Icon in the main window's project directory tree.
The PLC Settings Dialog Box will be displayed.
Install the Units.
000000 CT00
CLR
000000 I/O TBL ?
CH
SHIFT
*DM
000000 I/O TBL
CHG
WRIT
000000 I/O TBL
WRIT
000000CPU BU ST?
WRITE
0:CLR 1:KEEP
000000 I/O TBL
WRIT OK
000000 CT00
CLR
Section 4-2
Programming
Console
????
????
Password (9713)
217