Omron CJ - 09-2009 Operation Manual page 266

Examples
218
2. Make the required settings.
3. After completing the settings, transfer the PLC Setup to the PLC.
Making the Settings with the Programming Console
When a Programming Console is used to set the PLC Setup, the PLC Setup
settings are arranged by word addresses. Refer to the provided Programming
Console settings sheet for details.
Setting with a Programming Console
In this example, the Programming Console is used to set the Watch Cycle
Time (maximum cycle time) in 10-ms units.
The following diagram shows the required Programming Console operations.
Address Bits
209 15
0 to 14
FUN
Specifying a word address in the PLC Setup.
(Example: 209)
2 0
Setting
Enable for Watch Cycle Time
setting
Watch Cycle Time setting
000000 CT00
CLR
PC SETUP
VRFY
0:MODE1:PC SETUP
PC SETUP
1
+000 0000
PC SETUP
9
+209
Section 4-2
Setting range
0: Use default
1: Use setting in
bits 0 to 14.
0001 to 0FA0