Omron CJ - 09-2009 Operation Manual page 147

Basic System Configuration
Connecting Programming Devices
Connecting Personal Computers Running Support Software
Connecting to Peripheral Port
DOS computer
(RS-232C, 9-pin)
Connecting to RS-232C Port
DOS version
(RS-232C, 9-pin)
RS-232C
Connecting Cables for Peripheral Port
Computer
DOS
Peripheral
port
Note
The CS1W-CN118 Cable is used with an RS-232C
cable to connect to the peripheral port on the CPU Unit
as shown below. The CS1W-CN118 Cable cannot be
used with an RS-232C cable whose model number
ends in -V for a peripheral bus connection and must be
used for a Host Link (SYSMAC WAY) connection.
Connecting Cables for RS-232C Port
RS-232C Cable
XW2Z-200S-CV
or XW2Z-200S-V: 2 m
XW2Z-500S-CV
or XW2Z-500S-V: 5 m
Note
RS-232C port
Cable Length
0.1 m
CS1W-CN118
2.0 m
CS1W-CN226
CS1W-CN626 6.0 m
RS-232C Cable
XW2Z-200S-@@: 2 m
XW2Z-500S-@@: 5 m
Computer Cable
DOS XW2Z-200S-CV
or XW2Z-200S-V
XW2Z-500S-CV
or XW2Z-500S-V
The XW2Z-200S-CV and XW2Z-500S-CV use static-
resistant connectors and can be connected to the
peripheral bus or the Host Link. The XW2Z-200S-V
and XW2Z-500S-V, however, can only be connected
to the Host Link, not the peripheral bus.
Section 2-3
Computer
connector
D-Sub,
9-pin
CS1W-CN118 Cable
Peripheral
port
Computer
Length
connector
2.0 m D-Sub,
9-pin
5.0 m
99