Setting The Print Start Position - Epson ML-13000 User Manual

ML-13000 User's Manual
B
Touch / or touch the area where the numerical value is displayed, enter the numerical value, and set
the detection height.
If the Sensor Sensitivity is set to 0 mm, detection is performed at the height of the print head from the belt.
If you want height detection at a position lower than the print head height, set the value between 0 and -2
mm. If you want detection at a higher position, set it between 0 and + 2 mm.
Note:
If the detection position is set between 0 and -2 mm when the height from the belt to the print head is 2 mm or less,
the machine may detect fabric even if there is nothing on the belt.
If the detection position is set between 0 and + 2 mm when the height of the print head is 10 mm or more from the
belt, the machine may not detect floating fabric.
C
Touch OK.

Setting the Print Start Position

A
Use a ruler, tape measure, or other measuring instruments attached to the front cover to measure the
distance from the belt edge (standard position) on the right side to the position where you want to start
printing.
A
Print Start Position (X direction)
B
Edge of belt (standard position)
B
Set the Print Start Position on the Home screen on the control panel.
Touching / allows you to change the values.
Basic Operations
94