Epson ML-13000 User Manual page 334

ML-13000 User's Manual
D
Immediately after the glue is used up from the blade, spray soapy water on the entire belt.
If the glue is not uniformly distributed, spray the local area with soapy water avoiding areas where the glue
remains.
When to spray with soapy water
The illustration shows a side view of the gap between the blade and the belt. As soon as the glue starts to flow and is
no longer visible from the front of the blade, spray it with soapy water (illustration
A: Belt rotation direction
B: Blade
C: Glue
D: Soapy water
A
: Glue has accumulated in front of the blade.
B
: Glue in front of the blade is running low. Prepare soapy water.
C
: Glue is no longer visible from the front of the blade. Spray with soapy water at this time.
D
: Soapy water is flowing under the blade. Once you have sprayed the area with soapy water, always spread the
soapy water out so that it does not dry out.
The soapy water acts as a lubricant so the blade slides smoothly on the belt.
Once you have sprayed the area with soapy water, always spread the soapy water out so that it does not dry
out.
Maintenance
334
C
).