Epson ML-13000 User Manual page 26

ML-13000 User's Manual
: Pause (Suspend) button
Appears as the Start button while warming up, until the heater reaches the set temperature. Touching
this button starts printing, even if the heater temperature is low.
: Estimated time until completion
: Progress bar
Pauses printing
Touching the Pause button while printing displays a screen for selecting the timing to suspend, touch
one to select it.
❏
Immediate pause: Stops printing immediately.
❏
Pause between jobs: Stops at the end of the job currently printing.
Touch Resume on the paused screen to continue printing. Touch Cancel to cancel printing.
C
Fabric information
Displays information about the fabric that is loaded. The number indicates the fabric setting number. Touch
the display area to show the Fabric Settings menu.
"Fabric Settings Menu" on page 358
U
D
Print Width
Displays the print width of the fabric.
Touch / to change the print width in increments of 1 mm.
You can directly enter the value by touching the Print Width value display area. After entering the value, press
OK to set the value.
E
Fabric Feed Adjustment information during printing
If you perform Fabric Feed Adjustment while printing, the adjusted values appear here. Touching the display
area shows the settings screen.
"Changing settings while printing" on page 29
U
F
Belt cleaning tank
Switches between raised and lowered belt cleaning unit. The display changes as follows, depending on the sta‐
tus.
: Lowered status
Lift Up
Set Down : Raised status
❏
When pulling out the belt cleaning unit, lower it before pulling it out. You cannot pull it out when the unit is raised.
❏
When feeding the belt, raise the belt cleaning unit. If the belt is fed while the unit is lowered, water droplets will remain
on the belt.
Before Use
26