Product Curing; Check Belt Surface; Belt Curing - Epson ML-13000 User Manual

ML-13000 User's Manual
A
From the Maintenance screen on the control panel, touch Maintenance - Adhesive Material Maintenance.
B
Enter the administrator password.
c
Important:
❏ Change the default administrator password to a new password to ensure that only users who know the
administrator password can switch to maintenance mode. See the following for details on making
changes. The printer and the computer must be connected to the same network when making changes.
"How to Set/Change the User Name and Administrator Password" on page 53
U
❏ Save the password you set in a safe location so that you do not forget it.
See the following if you forget your password.
"If you have forgotten your administrator password" on page 379
U
C
Touch Application Mode - Start.
When you touch Forward or Reverse once on the control panel, the belt will continue to rotate until you
touch Suspended.
Touch Done to exit Application Mode and return to the mode selection screen.
c
Important:
Normally, you cannot operate the control panel when any cover is open or the belt cleaning unit is pulled out.
Therefore, if you return to the home screen during glue maintenance operations, you will not be able to
return to Maintenance mode until you close the front cover or the belt cleaning unit. Make sure you do not
touch the panel until you are ready, as it may result in performing curing again, setting the jigs again, or
failure of glue maintenance operations.

Product curing

Cover the product so that glue remover, soapy water, and so on does not enter under the product and cause a
malfunction.
This uses the same curing method as for glue removal (step 4 and on).
"Product curing" on page 299
U
If curing has already been performed, no work is required.

Check belt surface

Check the belt surface for any glue residue.
Press the Feed button on the front panel and circle the belt to confirm.
If there is any glue residue, clean it off.
"Belt surface cleaning" on page 312
U

Belt curing

From the front of the printer, apply insulating tape (25 mm [0.98 inches] wide x 0.2 mm [0.008 inches] thick) to
both edges of the belt. Affix insulating tape completely around the belt.
Maintenance
320