Printing Work - Epson ML-13000 User Manual

ML-13000 User's Manual
Inspection locations
Sensor
Emergency stop device
Air supply regulator
Cleaning pad blade
Suction cap

Printing Work

The workflow for printing is as given below.
Inspection before starting printing
Inspect the cleaning pads before starting printing. After inspection, clean or replace parts if necessary.
"Inspecting/Cleaning the Cleaning Pad" on page 174
U
Checking the Status of the Fabric
Before installing the fabric roll, make sure that the fabric is not creased, wrinkled, or frayed.
"Checking the Status of the Fabric" on page 60
U
Installing the fabric roll
Pass the fabric roll through the feeding spindle and install it in the feeding unit.
"Installing the Fabric Roll" on page 60
U
Loading the fabric into the printer
Pull out the fabric end of the installed fabric roll, pass it through a tension roller, and then install it on the belt.
"Loading the Fabric into the Printer" on page 76
U
Basic Operations
Frequency
Everyday Every week
Reference
Every month
U
Sensors" on page 170
U
Device" on page 172
U
Supply Regulator" on page 173
U
Blades" on page 189
U
page 198
59
"Inspecting/Cleaning the
"Inspecting the Emergency Stop
"Inspecting/Draining the Air
"Cleaning the Cleaning Pad
"Cleaning the Suction Caps" on