Epson ML-13000 User Manual page 360

ML-13000 User's Manual
Item
01 XXXXXXXXXX to 50 XXXXXXXXXX
Change Name
Fabric Type
Fabric Thickness
Head Height
Heater
Heater
Temperature
Print Length Management
Auto Reset
Manual Reset
Control Panel Menu
Parameter Description
Change the registered fabric settings. New registrations are normally
done when loading fabric.
Change Name allows you to change the registered name.
cotton
Under Fabric Type, select the fabric type to be used.
Fabric Thickness sets thickness of the fabric. If the fabric does not have
silk
a consistent height, such as for shaggy fabric, enter the average value.
wool
Head Height sets the height of the head. 0.7 mm is the recommended
value. A minimum height of 2 mm above the thickness of the fabric is
PET
secured.
Heater configures the heater for the heated pressure roller. If the fabric
PA
does not easily adhere to the belt, turn On the heater.
Turning it On enables Temperature. Heater temperature is adjustable.
Stretch fabrics
Switching fabric type resets the previously set temperature and sets the
recommended temperature for the selected fabric type.
PET/cotton
Others
0.0 to 5.0 mm (0.0 to
0.20 inches)
0.0 to 9.0 mm (0.0 to
0.35 inches)
Off
On
35 to 60˚C(68 to 140
˚F)
* Select either Off (do not automatically reset the value for Print Length)
Off
or After Last Page (reset when starting to print the next job).
When Off is selected, the value does not reset until you do Manual
After Last Page
Reset. However, once the value reaches 9999, it automatically resets and
returns to 0.
When After Last Page is selected, the value returns to 0 when printing
starts for the next job so you can check the print length per job. You can
also check how far along the print job is while printing.
When reset is done, the value for Print Length returns to 0.
360