Epson ML-13000 User Manual page 322

ML-13000 User's Manual
Note:
If you do not have 25 mm (0.98 inches) wide insulating tape, you can use 19 mm (0.75 inches) wide tape instead.
Complete steps 1 through 3 of the blade installation procedure before applying the insulating tape.
"Installing the blade" on page 324
U
1. Before applying the tape, insert a hex key or a similar tool into the hole in the blade support to raise the blade
for installation.
2. Mark the blade 25 mm (0.98 inches) from the edge of the belt.
3: Align the edge of the tape with the mark on the blade and stick it in place.
A
Hex key
B
Tape
C
Mark
B
Worker 1: While gripping the insulating tape attached to the belt with your hand, pull the tape straight out
along the edge of the belt.
Worker 2: Press and hold the Backfeed button on the front panel to rotate the belt in the reverse direction.
c
Important:
If air bubbles are formed or the tape swerves midway, peel off the tape and reapply new tape.
Maintenance
25 mm
(0.98 inches)
322