Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 97

[Energy Saver] key is turned off
A specified period of time has passed
* The time specified in Settings/Registration> Preferences> Timer/Energy Settings> Auto Sleep Time
Standby
The mode that the machine is running or can start operation immediately and all power is supplied in this mode.
Sleep Standby
The state that only the Control Panel is off while the power is supplied to all other parts.
Sleep 1
The state that the controller's all-night and non-all-night power is supplied while the Control Panel is off.
Deep Sleep
In this state, the Control Panel is off while only all-night power is supplied.
When any of the following "Conditions for Not Entering Deep Sleep" applies, transition to this mode does not occur.
■ Conditions for Not Entering Deep Sleep Mode (Check Items)
Settings of Settings/Registration
When the following settings are enabled in the [Settings/Registration] menu, the machine does not enter Deep Sleep mode.
The corresponding items are shown below.
Preferences > Timer/Energy Settings
• Sleep Mode Energy Use > High
• Sleep Mode Energy Use > Low > Compensate for Network Comm.
• Within the time specified in Auto Sleep Time
Preferences > Network
• NetWare Settings > Use NetWare > ON
• AppleTalk Settings > Use AppleTalk > ON
• TCP/IP Settings > BMLinkS Settings > Use BMLinkS > ON (*1)
• IEEE 802.1X Settings > Use IEEE 802.1X > ON
• TCP/IP Settings > IPv4 Settings > IP Address Settings > Auto IP > ON
• TCP/IP Settings > DNS Settings > mDNS Settings > Use mDNS > ON
• Google Cloud Print Settings > Use Google Cloud Print > ON (*2)
• TCP/IP Settings > SIP Settings > NGN Settings > Use NGN > ON (*1)
• Direct Connection Settings > Use Direct Connection > ON
Standby
or
Sleep Mode
Sleep Standby
Energy Use
"Low"
Job end
Job submission
Deep Sleep
Reader Control panel
Engine
Main Controler
[Energy Saver] key is turned on
Energy Use
"High"
Job submission
Job end
Sleep 1
86
2. Technology
State of power
supply ON
Energy Saving
State of power
supply OFF