Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 460

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
DFTBK-R
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFTAR3-R
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
DFTAR3-G
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
1 Enter shading target VL (R): back side
To enter the shading target value of Red on the back side at DADF stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Back), execute DF-WLVL1 and DF-WLVL2 and write the value
which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When the Copyboard or DADF (reverse model) is installed, the setting of this item is disabled.
0 to 2047
1103
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1
1 Enter shading target VL (R): front, 3rd
To enter the shading target value of Red on the front side at the third reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1103
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1 Enter shading target VL (G): front, 3rd
To enter the shading target value of Green on the front side at the third reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1111
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
449
8. Service Mode