Setting Of Menu Switch (Menu) - Canon imageRUNNER ADVANCE 715iF III Series Service Manual

CAUTION:
When changing this switch, make sure to turn OFF and then ON then ON the power supply twice. This is the specification
for changing the fax configuration and is the same specification as adding the Fax Board to the existing machine.
Details of Bit 4
This is the switch to set to display the send job stop confirmation screen if the Stop key is pressed during sending fax.
0: No
1: Yes
Details of Bit 5
This is the switch to set to stop the ongoing send job or incomplete send job if the Stop key is pressed during sending fax.
0: Incomplete send job
1: Ongoing send job

Setting of Menu Switch (MENU)

■ Configuration of Menu Switches
No.
005
006
007
008
009
010
005: NL equalizer
Select ON/OFF of NL equalizer.
Select "1: ON" in the case of frequent errors caused by line status at the time of communication.
NOTE:
Error codes caused by line status at the time of transmission
##100, ##101, ##102, ##104, ##201, ##281, ##282, ##283, ##750, ##755, ##765, ##774, ##779, ##784, ##789
Error codes caused by line status at the time of reception
##103, ##107, ##114, ##201, ##790, ##793
006: Phone line monitoring
Set whether to make monitoring tone of the phone line from the speaker.
• 0 (DIAL):
To make monitoring tone of the phone line from the speaker from the start of line connection until the DIS.
Sssw Menu Num Ncu Type IPFAX Print Clear Test
<1/3>
001 xxxxx ← yyyyy {aaaaa bbbbb}
← yyyyy {aaaaa bbbbb}
002 xxxxx
← yyyyy {aaaaa bbbbb}
003 xxxxx
← yyyyy {aaaaa bbbbb}
004 xxxxx
← yyyyy {aaaaa bbbbb}
005 xxxxx
← yyyyy {aaaaa bbbbb}
006 xxxxx
007 ← yyyyy {aaaaa bbbbb}
xxxxx
008 ← yyyyy {aaaaa bbbbb}
xxxxx
Function
NL equalizer
Phone line monitoring
Transmission level (ATT)
Upper limit for V.34 modulation speed
Upper limit for V.34 data speed
Frequency of pseudo CI signal
624
Report
<READY>
OK
1: ON, 0: OFF
0 to 3
8 to 15 (ex: 15 = -15 dBm)
0: 3429, 1: 3200, 2: 3000, 3: 2800, 4: 2743,
5: 2400
0 to 13
0: 50 Hz, 1: 25 Hz, 2: 17 Hz
8. Service Mode
Scope of selection