Function (Operation / Inspection Mode) - Canon imageRUNNER ADVANCE 715iF III Series Service Manual

FUNCTION (Operation / inspection mode)

FEEDER (ADF service mode) > FUNCTION (Operation / inspection mode)
MTR-CHK 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
FEED-CHK 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
CL-CHK 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
CL-ON 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
FAN-CHK 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
Specification of DADF operation motor
To specify the motor of DADF to operate.
The motor is activated by MTR-ON.
At operation check
Enter the setting value, and then press OK key.
0: ADF Motor (M4201)
FEEDER> FUNCTION> MTR-ON
Specify DADF individual feed operation
To specify the feed mode for DADF.
Feed operation is activated by FEED-ON.
At operation check
Enter the setting value, and then press OK key.
0: 1-sided pickup/delivery operation
FEEDER> FUNCTION> FEED-ON
Specifying DADF Operation Clutch
To specify the DADF Clutch to be operated.
The Clutch is activated by CL-ON.
At operation check
Enter the value, and then press OK key.
0 to 1
0: ADF Pickup Clutch (CL4200), 1: ADF Registration Clutch (CL4201)
FEEDER> FUNCTION> CL-ON
Operation check of DADF Clutch
To start operation check for the Clutch specified by CL-CHK.
- When CL-CHK=0
The ADF Motor (M4201) and the ADF Pickup Clutch (CL4200) are turned ON => The ADF Pickup
Roller rotates positively for approx. 1 second => The motor stops after 5 seconds from turning OFF
the clutch.
- When CL-CHK=1
The ADF Motor (M4201) and the ADF Registration Clutch (CL4201) are turned ON => The ADF
Registration Roller rotates positively for approx. 5 seconds => The motor stops after 5 seconds
from turning OFF the clutch.
At operation check
1) Select the item, and then press OK key.
The roller stops automatically after positive rotation.
2) Press OK key.
The operation check is completed.
Press OK key again after execution. It stops automatically after approx. 5 sec; however, it does
not finish unless OK key is pressed (STOP screen does not appear.)
FEEDER> FUNCTION> CL-CHK
Specification of DADF operation fan
To specify the fan of DADF to operate.
The fan is activated by FAN-ON.
At operation check
Enter the setting value, and then press OK key.
0: ADF Cooling Fan (FAN)
FEEDER> FUNCTION> FAN-ON
606
8. Service Mode