Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 447

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
DFCH2G10 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF-M1 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF-M2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
Complex chart No.10 data (G) entry:front
To derive the front/back side linearity, enter the Green data on the front side of No.10 image in
DADF complex chart.
Enter the value of service label on the Reader.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2550
0
COPIER> ADJUST> CCD> DFCH2R2/10, DFCH2B2/10, DFCH2G2
1
MTF value 1 entry: Copyboard, horz scan
To enter the setting value 1 for calculating MTF filter coefficient in horizontal scanning direction at
copyboard reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Front), enter the value of service label on a new unit.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
MTF value 2 entry: Copyboard, horz scan
To enter the setting value 2 for calculating MTF filter coefficient in horizontal scanning direction at
copyboard reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Front), enter the value of service label on a new unit.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
436
8. Service Mode