Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 517

COPIER (Service mode for printer) > OPTION (Specification setting mode) > DSPLY-SW
PCMP-DSP 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
ERR-DISP 2
SVC-ACA 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
Supplement/Memo
SVC-SRA 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
Set copy cmpl scrn dspl:chg w/devc alone
To set whether to display the screen indicating completion of copying at the time of charging with
a device alone.
When 0 is set, a message "Copying is complete. Do you want to start the job again with the same
settings?" is not displayed in a pop-up screen.
When COIN is 4, this setting is enabled.
Upon user's request
Enter the setting value, and then press OK key.
0 to 1
0: OFF, 1: ON
1
COPIER> OPTION> ACC> COIN
[For customization]
Display of ACA installation button
To set whether to display the [Install Auto Configuration Agent] button on the CDS Updater screen
(user mode/service mode).
When switching to install/not to install the ACA via network
Enter the setting value, and then press OK key.
0 to 2
0: Hide (Hide user mode/service mode)
1: Display only service mode (Hide user mode)
2: Display all (Display user mode/service mode)
It differs according to the location.
Service Mode > Updater
Management Settings> License/Other> Register/Update Software
ACA : Auto Configuration Agent
Display/hide of DBS installation button
To set whether to display the [Install Data Backup Service] button on the CDS Updater screen
(user mode/service mode).
When switching to install/not to install the Data Backup Service via network
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Depending on the setting value, display when entering from Settings/Registration and that from
service mode differ.
0 to 2
0: Hide (Hide user mode/service mode)
1: Display only service mode (Hide user mode)
2: Display all (Display user mode/service mode)
It differs according to the location.
Service Mode> Updater> Install Data Backup Service
Management Settings> License/Other> Register/Update Software> Install Data Backup Service
506
8. Service Mode