Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 543

COPIER (Service mode for printer) > OPTION (Specification setting mode) > USER
DPT-ID-7 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
RUI-RJT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SND-RATE 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Additional Functions
Mode
FREG-SW 2
IFAX-SZL 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
Supplement/Memo
Password entry set at dept ID reg/auth
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to require a password entry at the time of registration/authentication of department
ID.
With the setting to require entry, entry of 7-digit password is required as well as entry of department
ID.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Department ID only, 1: 7-digit (password) entry
0
Connct set at invalid auth from remoteUI
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set to disconnect HTTP port when the machine receives invalid authentication from remote UI
3 times.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Continued connection, 1: Disconnected
0
Set compress ratio at SEND high compress
To set the compression ratio when the data compression ratio for SEND (transmission) is set to
"High Rati".
As the value is larger, the compression ratio is higher (the file size becomes small).
When making the transmission file size smaller
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
As the value is larger, image quality is decreased.
0 to 2
0: Compression ratio 1/16, 1: Compression ratio 1/20, 2: Compression ratio 1/24
0
Function Settings> Send> Common Settings> Data Compression Ratio
For R&D
Set of I-Fax transmission size limit
To set for restricting data size at the time of I-Fax transmission that does not go through the server.
With the setting to restrict the data size, it is to be #830 error in the case of sending data that
exceeds the upper limit value.
In the case that the data goes through the server, the size of transmission data is always restricted.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Limited, 1: Not limited (Restriction applies when data goes through the server.)
1
Function Settings> Send> E-Mail/I-Fax Settings> Maximum Data Size for Sending
Set the upper limit value for transmission data size in Settings/Registration menu.
532
8. Service Mode