Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 547

COPIER (Service mode for printer) > OPTION (Specification setting mode) > USER
LDAP-SW 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
FROM-OF 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
FILE-OF 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
MAIL-OF 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Retrieval condition set for LDAP server
To set the condition to search e-mail address, etc. from LDAP server.
When specifying condition to search e-mail address, etc. from LDAP server
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 5
0: Includes the next, 1: Not include the next, 2: Equivalent to the next, 3: Not equivalent to the next,
4: Starts with the next, 5: Finishes with the next
4
LDAP (Lightweight Directory Access Protocol): Registering LDAP server enables to search e-mail
address, etc. from LDAP server and the result can be registered in the Address Book, etc.
Registration is available by the following: Set Destination > Register LDAP Server
Deletion of mail sender's address
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to delete the sender's address (From) at the time of e-mail transmission.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Retained, 1: Deleted
0
Set file transmission to entered address
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to allow file transmission to a newly entered address.
When 1 is set, file transmission is not available by entering the address because "File" is not
displayed on the transmission screen.
The addresses already registered in the Address Book can be used.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
To restrict addresses for transmission, be sure to manually delete them because the addresses
registered in the Address Book can be used.
0 to 1
0: Enabled, 1: Disabled
0
Setting of e-mail TX to entered address
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to allow e-mail transmission to a newly entered address.
When 1 is set, e-mail transmission is not available by entering the address because "E-mail" is not
displayed on the transmission screen.
The addresses already registered in the Address Book can be used.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
To restrict addresses for transmission, be sure to manually delete them because the addresses
registered in the Address Book can be used.
0 to 1
0: Allowed, 1: Prohibited
0
536
8. Service Mode