Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 461

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
DFTAR3-B 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST-BW0 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
OFST-BW1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Enter shading target VL (B): front, 3rd
To enter the shading target value of Blue on the front side at the third reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1164
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
Adj CIS-ch0 offset:front,B&W mode,600dpi
To adjust the offset value (black level)
of the Scanner Unit (for front side)
on channel 0 in Black & White mode with 600 dpi.
The value is updated by executing CL-AGC.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (for front side)
Enter the setting value, and then press OK key.
When replacing the CIS, rewrite the value on the label by displaying this item after executing
COPIER>FUNCTION>CCD>CL-AGC.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS-ch1 offset:front,B&W mode,600dpi
To adjust the offset value (black level)
of the Scanner Unit (for front side)
on channel 1 in Black & White mode with 600 dpi.
The value is updated by executing CL-AGC.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (for front side)
Enter the setting value, and then press OK key.
When replacing the CIS, rewrite the value on the label by displaying this item after executing
COPIER>FUNCTION>CCD>CL-AGC.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
450
8. Service Mode