Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 430
Hide thumbs
Also See for imageRUNNER ADVANCE 715iF III Series:
- Faq manual (92 pages) ,
- Getting started (12 pages)
Table of Contents
Advertisement
COPIER (Service mode for printer) > DISPLAY (State display mode) > ANALOG
FIX-C
Detail
Use Case
Display/Adj/Set Range
Default Value
FIX-E
Detail
Use Case
Display/Adj/Set Range
Default Value
FIX-E2
Detail
Use Case
Display/Adj/Set Range
Default Value
■ CST-STS
COPIER (Service mode for printer) > DISPLAY (State display mode) > CST-STS
WIDTH-MF
Detail
Use Case
Adj/Set/Operate Method
Unit
Amount of Change per
Unit
■ CCD
COPIER (Service mode for printer) > DISPLAY (State display mode) > CCD
TARGET-B
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Appropriate Target Value
TARGET-G
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Appropriate Target Value
1
Dspl of Fixing Roller center temperature
To display the center temperature of the Fixing Roller detected by the Fixing Main Thermistor.
When checking the temperature at the center of Fixing Roller
0 to 300
0
1
Dspl of Fixing Roller edge temperature
To display the edge temperature of the Fixing Roller detected by the Fixing Sub Thermistor 1.
Fixing Sub Thermistor 1 is located in the drive side of Fixing Roller.
When checking the edge temperature of the Fixing Roller
0 to 300
0
1
Dspl of Fixing Roller edge temperature
To display the edge temperature of the Fixing Roller detected by the Fixing Sub Thermistor 2.
Fixing Sub Thermistor 2 is located in the non-drive side of Fixing Roller.
When checking the edge temperature of the Fixing Roller
0 to 300
0
2
Display of MP Tray paper width size
To display the paper width size set on the Multi-purpose Tray.
When checking the paper width side set on the Multi-purpose Tray
N/A (Display only)
mm
1
2
Shading target value (B)
To display the shading target value of Blue.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- At scanned image failure
N/A (Display only)
0 to 2047
512 - 2047
2
Shading target value (G)
To display the target value of Green.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- At scanned image failure
N/A (Display only)
0 to 2047
512 - 2047
419
8. Service Mode
Advertisement
Table of Contents
Troubleshooting
