Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 444
Hide thumbs
Also See for imageRUNNER ADVANCE 715iF III Series:
- Faq manual (92 pages) ,
- Getting started (12 pages)
Table of Contents
Advertisement
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
MTF2-S7
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF2-S8
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF2-S9
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
MTF value 7 entry:DADF, front, vert scan
To enter the setting value 7 for calculating MTF filter coefficient in vertical scanning direction on
the front side at DADF stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Front), enter the value of service label on a new unit.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
MTF value 8 entry:DADF, front, vert scan
To enter the setting value 8 for calculating MTF filter coefficient in vertical scanning direction on
the front side at DADF stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Front), enter the value of service label on a new unit.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
MTF value 9 entry:DADF, front, vert scan
To enter the setting value 9 for calculating MTF filter coefficient in vertical scanning direction on
the front side at DADF stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Front), enter the value of service label on a new unit.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
20 to 85
50
COPIER> FUNCTION> CCD> MTF-CLC
1
433
8. Service Mode
Advertisement
Table of Contents
Troubleshooting
