Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 593

COPIER (Service mode for printer) > TEST (Print test mode) > PG
PG-QTY 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
FINISH 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
■ NETWORK
COPIER (Service mode for printer) > TEST (Print test mode) > NETWORK
PING 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Supplement/Memo
Setting of PG output quantity
To set the number of sheets for PG output.
At trouble analysis
Enter the setting value, and then press OK key.
1 to 999
sheet
1
1
Accessory processing function test print
To execute the test print relating to accessory processing function.
When checking operation of accessory processing function
1) Enter the number of sheets for PG-QTY, and then press OK key.
2) Enter the setting value, and then press OK key.
3) Press Start button.
The machine outputs a test print.
0 to 99
0: N/A
1: Staple (Finisher, front)
Any values other than those mentioned above: Not used
0
COPIER> TEST> PG> PG-QTY
Network connection check
To check connection between this machine and TCP/IP network.
- When checking network connection at the time of installation
- At network connection failure
1) Turn OFF the main power switch.
2) Connect the network cable to this machine, and then turn ON the main power switch.
3) Inform the system administrator at user's site that installation of this machine is complete, and
ask for network setting.
4) Ask the system administrator to check the network connection, and check the remote host
address of PING transmission target.
5) Select the item and enter the remote host address, and then press OK key and Start key.
OK: Connection is normal. Checking procedure is complete.
NG: Connection failed. Go to step 6) if the cable connection is OK. In case of cable connection
failure, connect again and then go to step 5).
6) Select the item and enter loopback address, and then press OK key and Start key.
OK: TCP/IP setting of this machine is normal. Go to step 7) to check NIC.
NG: TCP/IP setting of this machine has failure. Go to step 3) to check the setting again.
7) Select the item and enter the local host address, and then press OK key.
OK: Network setting of this machine and NIC are normal. Inform the system administrator that the
trouble is due to network environment and ask for countermeasure.
NG: Connection failure/fault with NIC. Check connection of NIC/ replace NIC.
0.0.0.0 to 255.255.255.255
At normal state: OK, At failure occurrence: NG
- Remote host address: IP address of PC terminal in network.
- Loopback address: 127.0.0.1. Checking TCP/IP of this machine is available because the signal
is returned before NIC.
- NIC: Network interface
- Local host address: IP address of this machine
582
8. Service Mode