Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 699

7.
<Only for 120 V product>
1x
8.
Connect the Power Plug to the outlet.
9.
Turn ON the Main Power Supply Switch.
Checking the Operation
■ Type Setting
1. From the following service mode, check that the type
setting of Fax board is set to the correct location
(country/region) and press OK.
FAX > TYPE > TYPE
2. Check that the value of the following service mode
is "0". If it is "1", change it to "0".
COPIER > OPTION > DSPLY-SW > SDTM-DSP
NOTE:
To change parameter to "0" makes no show below
[Settings/Registration > Preferences > Time/Energy
Settings > Auto Shutdown Time] and auto shut down is not
available.
3. After setting the user telephone number, turn OFF
and then ON the main power switch.
■ Basic Setting
NOTE:
When "System Manager Information Settings" is set, be
sure to follow the direction of user administrator in order
to log in as an administrator.
In this section, make only minimum settings required for FAX
communication.
1. Set the user telephone number.
[Settings/Registration] > [Function Settings] > [Send] >
[Fax Settings] > [Set Line] > [Line 1] > [Register Unit
Telephone Number] > Enter the fax number > [OK]
2. After setting the user telephone number, turn OFF
and then ON the main power switch.
■ FAX Communication Test
Perform communication test to check if FAX function works
correctly.
1. Switch the control panel display to Send/Fax
display.
2. Send the test document from this machine to
another machine that can handle the
communication test to check that this machine can
send the data correctly.
3. Send the test document from the target to this
machine to check if the machine can receive the
document properly.
688
9. Installation