Counter (Counter Mode) - Canon imageRUNNER ADVANCE 715iF III Series Service Manual

COPIER (Service mode for printer) > TEST (Print test mode) > NET-CAP
ENCDATA 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
CAPIF 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode

COUNTER (Counter mode)

■ TOTAL
COPIER (Service mode for printer) > COUNTER (Counter mode) > TOTAL
SERVICE1 1
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Setting of packet data encryption
To set whether to encrypt the packet data when writing the captured packet data to the USB flash
drive.
- At problem analysis (at packet data analysis)
- When improving security of written packet data
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
This setting is enabled only when writing data to the USB flash drive. Even when the packet data
is loaded using SST, the file is specified, therefore the setting is disabled.
0 to 2
0: Encrypted (encrypted file)
1: Not encrypted (plain text file)
2: Encrypted (encrypted file + plain text file)
0
Setting of network packet capture target
To set the network interface to capture the packet data.
Make this setting before starting network packet capture.
When changing the target of network packet capture
Enter the setting value, and then press OK key.
1 to 6
1 - Local loopback
Basically not used. Use only if analysis is required.
2 - Wired LAN
Used when Wired LAN is set in Settings/Registration > Preferences > Network > Interface.
3- Wireless LAN
Used when Wireless LAN is set in Settings/Registration > Preferences > Network > Interface.
4 - Wireless Soft AP Mode
Used when Access Point Mode is set in Settings/Registration > Preferences > Network > Direct
Connection.
5 - Wi-Fi Direct
Used when Wi-Fi Direct is set in Settings/Registration > Preferences > Network > Direct
Connection Settings.
6 - Wired LAN (Subline)
Use this when "Wired LAN + Wireless LAN" or "Wired LAN + Wired LAN" is set in Settings/
Registration > Preferences > Network > Interface, and you want to obtain communication on the
sub line side.
2
COPIER> TEST> NET-CAP
Service-purposed total counter 1
To count up when the printout is delivered outside the machine.
Large size: 1, Small size: 1
A blank sheet is not counted.
N/A (Display only)
0 to 99999999
585
8. Service Mode