Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 465

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
OFST2CL2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST2CL3 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST2CL4 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST2CL5 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
GAIN-CL0 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Adj CIS-ch2 offset:front,clr mode,600dpi
To adjust the offset value (black level) of the Scanner Unit (Front) on channel 2 in color mode with
600 dpi.
The value is updated by executing CL-AGC.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS-ch3 offset:front,clr mode,600dpi
To adjust the offset value (black level) of the Scanner Unit (Front) on channel 3 in color mode with
600 dpi.
The value is updated by executing CL-AGC.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS-ch4 offset:front,clr mode,600dpi
To adjust the offset value (black level) of the Scanner Unit (Front) on channel 4 in color mode with
600 dpi.
The value is updated by executing CL-AGC.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS-ch5 offset:front,clr mode,600dpi
To adjust the offset value (black level) of the Scanner Unit (Front) on channel 5 in color mode with
600 dpi.
The value is updated by executing CL-AGC.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS gain level:front,clr mode,300dpi
To adjust the detection level (gain level) of the Scanner Unit (Front) in color mode with 300 dpi.
The value is updated by executing CL-AGC.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 255
0
COPIER> FUNCTION> CCD> CL-AGC
454
8. Service Mode