Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 503

COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
W/SCNR 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SVMD-ENT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
KSIZE-SW 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
PDF-RDCT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SJB-UNW 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Setting of Reader Unit installation
To set installation of the Reader Unit.
When the Reader Unit is detected at startup of the machine, "1: Installed" is set automatically.
When installing/removing the Reader Unit
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Not installed, 1: Installed
0 (Printer model)/1 (Copier model)
Setting of entry method to service mode
To set the way to get in service mode to prevent information leak.
As needed
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Factory default
1: [Settings/Registration] - Pressing [4] and [9] at the same time - [Settings/Registration]
0
Setting of K-size paper support
To set detection/display of K-size paper (for China).
When MODEL-SZ is 0, this setting is enabled.
When using K size paper
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Not supported, 1: Supported
It differs according to the location.
COPIER> OPTION> FNC-SW> MODEL-SZ
8K paper: 270 x 390 mm, 16K paper: 270 x 195 mm
PDF reduction set at forwarding
To set whether to reduce the image for transmission when converting the image received by I-Fax
into PDF for e-mail/file transmission.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Following the current setting, 1: Image reduction
0
Reserve upper limit of secured print job
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the upper limit for the number of reserved jobs in secured print job.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2
0: 50 jobs, 1: 90 jobs, 2: No limit
1
492
8. Service Mode