Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 510

COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
NO-LGOUT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
JM-ERR-R 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
ASLPMAX 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SEND-SPD 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Display/hide of logout button
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to display or hide [Logout] button.
When 0 is set, [Logout] button is displayed on the screen, and logout with the ID key is enabled.
(Normal)
When 1 is set, [Logout] button is not displayed, and logout with the ID key is disabled.
Upon user's request (for customization, etc.)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Display, 1: Hide
0
Set of error display of 0071 jam (RCON)
To set whether to display 0071 jam as the error "E996-0071".
In the case of a jam, a log may not be able to be obtained depending on the timing.
By selecting 1 when the 0071 jam occurs, it is displayed as an error so that a log can be obtained.
When obtaining a log at the occurrence of 0071 jam
Enter the setting value, and then press OK key.
0 to 1
0: Display as a jam, 1: Display as an error
0
COPIER> OPTION> FNC-SW> JM-ERR-D
Set auto sleep shift time maximum value
Set auto sleep shift time maximum value.
Upon user's request
Enter the setting value, and then press OK key.
0 to 1
0: 240minutes, 1: 120 minutes
It differs according to the location.
ON/OFF of SEND operation speed-up
To set whether to speed up the SEND operation.
Usually, speed of SEND/XBOX is increased by performing image conversion during SEND and
Scan.
Reading speed may decrease when scanning large size color original at high resolution or when
competing operation occurs with another job during scanning. Set 1 to keep the speed.
When failure with MEAP application occurs, set 1.
- When reading speed is decreased during SEND and Scan
- When failure with MEAP application occurs
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: ON, 1: OFF
0
499
8. Service Mode