Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 490

■ PART-CHK
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > PART-CHK
CL
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
CL-ON
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
MTR
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
MTR-ON
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
1 Specification of operation clutch
To specify the clutch to operate.
When replacing the clutch/checking the operation
Enter the value, and then press OK key.
6 to 9
6: Not used
7: Cassette 2 Feed Clutch (CL602)
8: Duplex Feed Clutch (CL2)
9: Duplex Reverse Clutch (CL4)
6
COPIER> FUNCTION> PART-CHK> CL-ON
1 Operation check of Clutch
To start operation check of the clutch specified by CL.
The operation automatically stops after operation of 10 seconds.
When replacing the Clutch/checking the operation
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
COPIER> FUNCTION> PART-CHK> CL
1 Specification of operation motor
To specify the motor to operate.
When replacing the motor/checking the operation
Enter the setting value, and then press OK key.
0 to 4
0: Scanner Motor (M4)
1: Drum Motor (M2)
2: Developing Drive Unit (M2+SL2)
3: Fixing Motor (M1)
4: Fixing pressure release drive test (M1)
0
COPIER> FUNCTION> PART-CHK> MTR-ON
1 Operation check of Motor
To start operation check of the Motor specified by MTR.
The operation automatically stops after operation of 10 seconds.
When replacing the Motor/checking the operation
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
COPIER> FUNCTION> PART-CHK> MTR
479
8. Service Mode