Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 479

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > FEED-ADJ
ADJ-MFRE 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
RG-HF-SP 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
REG-DUP1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
REG-MF 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Write start pstn in horz scan:MPTray 2nd
To adjust the image write start position on the second side in the horizontal scanning direction
when feeding paper from the Multi-purpose Tray.
As the value is changed by 1, the left margin is changed by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
When clearing the Main Controller RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-25 to 50
mm
0
Adj of registration start timing: Heavy
To adjust the timing to turn ON the Registration Roller in the case of heavy paper.
As the value is incremented by 1, the margin on the leading edge of paper is increased by 0.1 mm.
+: Leading edge margin becomes larger.
-: Leading edge margin becomes smaller.
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
When changing the edge margin
When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch positive/negative by +/- key)
and press OK key.
Be sure to enter the adjustment value on the service label after adjustment.
-50 to 50
9
Rgst start timing adj: Plain, 2nd side
To adjust the leading edge margin by changing the timing to form image when feeding the second
side of plain paper.
As the value is changed by 1, the leading edge margin is changed by 0.1 mm.
+: Leading edge margin becomes larger. (An image moves downward.)
-: Leading edge margin becomes smaller. (An image moves upward.)
When adjusting the leading edge margin
When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch positive/negative by +/- key) and press OK key.
When replacing the DC Controller PCB/clearing RAM data, restore the backup data if data is
backed up or enter the value of service label if data is not backed up.
-50 to 50
9
Rgst start timing adj: MP Tray, Plain
To adjust the leading edge margin by changing the timing to form image when feeding the, of plain
paper 1/2, recycled paper, and thin paper.
As the value is changed by 1, the leading edge margin is changed by 0.1 mm.
+: Leading edge margin becomes larger. (An image moves downward.)
-: Leading edge margin becomes smaller. (An image moves upward.)
- When replacing the DC Controller PCB/clearing RAM data
- When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch positive/negative by +/- key)
and press OK key.
When replacing the DC Controller PCB/clearing RAM data, restore the backup data if data is
backed up or enter the value of service label if data is not backed up.
-50 to 50
5
468
8. Service Mode