Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 469

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
OFST4CL4 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST4CL5 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
GAIN3CL0 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
GAIN4CL0 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
LED3CL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Adj CIS-ch4 offset: back,clr mode,600dpi
To adjust the offset value (black level) of the Scanner Unit (Back) on channel 4 in color mode with
600 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS-ch5 offset: back,clr mode,600dpi
To adjust the offset value (black level) of the Scanner Unit (Back) on channel 5 in color mode with
600 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS gain level: back,clr mode,300dpi
To adjust the detection level (gain level) of the Scanner Unit (Back) in color mode with 300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
0
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS gain level: back,clr mode,600dpi
To adjust the detection level (gain level) of the Scanner Unit (Back) in color mode with 600 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
0
COPIER> FUNCTION> CCD> CL-AGC
Adj pry lgt src lgt time:back,clr,300dpi
To adjust the lighting time of the LED which is the primary light source of the Scanner Unit (Back)
in color mode with 300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 2928
1648
COPIER> FUNCTION> CCD> CL-AGC
458
8. Service Mode